-
Notifications
You must be signed in to change notification settings - Fork 16
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
cura 4.5 doesn't work #34
Comments
When I try to use the X3GWriter in CURA 4.5 the printer doesn't work, just in CURA 4.2.1 |
to add to this - it zeros out, but then doesn't move the bed down and move the heads over to the heat extruder spot (forward left corner, opposite the 0,0,0 spot) (whatever that command is). so, it just hangs. thanks. (old makerbot software generally works ok, but there isn't a horizontal expansion setting in the makerbot s/w, so, getting dimensionally accurate parts is tough without a lot of sanding) (the main reason i want to use cura, other than cura is just way more awesomer... |
That's probably because this plug-in writes it to a temporary file, because GPX requires a file name to write to (can't write to a stream) but Cura needs it as a stream. So it creates a temporary file, lets GPX write to that file, and then reads that file back in for Cura. I don't know what would make your printer firmware wait for homing. Perhaps the steps per mm are not configured correctly and it's homing extremely slowly or something? Or perhaps it thinks that the endstops are on the other side? I think that this is caused by having the wrong |
No description provided.
The text was updated successfully, but these errors were encountered: